General Purpose Pain Spray Gun with 1-Quart Canister and Fluid Control (Campbell Hausfeld DH420000AV)

This worked extremely well with latex paint. I set the compressor to 50 PSI, I didn't need to dilute the paint and it sprayed on very well. It clogged up pretty infrequently, but it was easy to clean when that happened.

I ordered one and it came damaged. I requested a new one and they send it right away. The new one work so well and it was easy to use! I’m actually very surprised, it worked well to paint exterior walls. I just had to thin the paint a bit. Overall it’s worth the money.

No muy buena calidad, se me quedó atorada y tocó devolverla

Bought this to spray interior doors during a remodel. I have a 120 max PSI Husky air compressor, which actually made it hard to find spray guns of any quality that would be compatible with my compressor (used mainly for airbrushing). The Campbell spray gun did the job nicely. While I'm pretty familiar with spray guns and compressors, the gun was easy to set up and use, and I would assume it would be just as easy for someone with no experience with spray guns.The gun comes with extra tips and clear instructions, as well as cleaning oil and necessary tightening tools. Easy to use, easy to clean. I have no complaints and am glad I purchased this. I probably would not try to use this to paint very large projects, say, the interior of a house or siding, but would be fine for baseboards, doors, trim, playhouses, fences, and other similarly sized projects.

Worked great when purchased. Tried to use yesterday. No air coming out of the gun when nozzle was pressed. Apparently the air set screw was jammed, On trying to remove this brass screw from the aluminum housing the head of the screw broke off. This brass screw was totally stuck.Had to trash this and ordered a different model (Astro Pneumatic Tool 4008 Spray Gun with Cup - Red Handle 1.8mm Nozzle)with a mechanical screw. Hopefully this will work better.

Very nice for what it is and for what purposes I use it. Not for painting automobiles unless you are not finicky about results. As always on new paint guns, make sure that you take it completely apart and clean it. This particular unit had metal chips from the manufacturing process in the head.

I used this paint gun with the PORTER-CABLE PCFP02003 3.5-Gallon 135 PSI Pancake Compressor which only has 2 cfm.It worked well. Although the compressor did kick in, it recovered quickly. I used it on some difficult parts of my deck railing. The gun covered well and was easy to use. I used latex and thinned it 10% and strained the paint.You must be careful cleaning it, even though I sprayed the gun with lots of fresh water right after spraying, the tip still needed cleaning.It is nice to have a paint Gun that will work with a small compressor....

First I'll start by saying I was spraying cabinet doors with primer and base coat both water based.At first it took awhile to get the thinning amount down and then it would spray great once I found the right setting .But stop spraying for 1 minute and it will not spray the same again. Take it all apart and clean it , sprays ok for 10 seconds and then acts up again.Lots of time chasing perfect settings just to be disappointed . Wasted lots of paint and hours of time just to end up rolling them